Catch the intruder inside the line
The floor reports the intruder after the wall and before the door.
The threat · Intruders crossing floors, decks or steps unseen?
Pressure sensors under tiles, stone, wood or steel turn any floor, deck or stair into a silent alarm zone.

D-Floor places D-FENCE pressure sensors on rails beneath the floor finish: tile, stone, wooden or stainless-steel flooring. The protected area has no size limit. When an intruder steps onto it, the change in pressure raises the alarm; animals under about 25 kg do not.
The floor reports the intruder after the wall and before the door.
The zone is hidden, so an intruder cannot step around it.
The weight threshold ignores animals under about 25 kg.
The same system is called D-Deck when it protects decking, passages, terraces and hallways, and D-Step when it is built into steps and stair treads. It installs permanently or temporarily, under metal, wooden or plastic surfaces, and stays invisible. The SECURITY Book lists D-Deck and D-Step for museums, high-rise buildings, offshore platforms and ships.
Typical zones: entrances and thresholds, pool decks, the floor in front of a safe or at the entrance to a classified room, and prison-cell floors. The alarm goes to the D-FENCE control centre and to the cameras, sirens and phone apps you connect.
Pressure sensors on rails sit under the tiles, boards or plates.
A person's weight changes the load; animals under about 25 kg stay below the threshold.
The alarm leaves as a dry contact or RS232 / RS485 message.
The D-FENCE control centre, cameras and phone apps receive the event.
Every image opens full size. Product sheets are shown whole, exactly as D-FENCE publishes them.
Paste it into your specification. It defines the system by what it must do, so any alternative must meet every point.
The system shall be D-Floor by D-FENCE Electronic Fencing and Security Systems Ltd. (ISO 9001:2015 certified quality management), or an approved equivalent that meets every requirement in this section.
Pressure sensors under tiles, stone, wood or steel turn any floor, deck or stair into a silent alarm zone.
Before installation, the contractor shall submit the manufacturer's datasheet, the installation instructions and the zone layout for approval.
Tell us the site, the threat and the line. D-FENCE engineers propose the right barrier, sensor and platform, ready for your integrator.

Intruders climbing over your wall?
A patented strain-gauge strip under the coping. Real weight on the wall raises the alarm; birds, cats and wind do not.

Walls climbed without anyone noticing?
An ultra-slim pressure sensor hidden under wall copings, gates and floors: it reports the climb and leaves the design untouched.

Artwork lifted off the wall unnoticed?
A hidden strain-gauge sensor behind each painting reports the moment it is dragged, lifted or replaced.
Products, solutions and pages