Invisible protection
The sensor hides under the finish, so the wall, gate or floor keeps its look.
The threat · Walls climbed without anyone noticing?
An ultra-slim pressure sensor hidden under wall copings, gates and floors: it reports the climb and leaves the design untouched.

D-Tech is the newest generation of the D-FENCE pressure sensor: an ultra-slim strip installed covertly on walls, fences or the ground. On a wall it sits under a metal or stone coping made to your height, width, length and colour. The moment an intruder puts his weight on the wall top, it raises the alarm.
The sensor hides under the finish, so the wall, gate or floor keeps its look.
It measures weight on the barrier; the catalogue false-alarm rate is under 1 per km per 3 months.
Wall tops, gates, decks, steps and interiors run on the same strip and controller.
The same sensor goes where a fence cannot: under gate frames, and under decks, steps and floors, including the floor in front of a safe. Each strip runs up to 6 m and carries a cover of up to 350 kg. The alarm threshold sits about 15 kg above the static weight of the cover, so rain, wind and small animals stay below it.
D-Tech outputs a dry contact (N.O. / N.C.) and RS485 to the alarm panel, CCTV, siren, floodlight, mobile app or control room you already use, and into D-Command Control.
The D-Tech strip lies under the coping, gate frame or floor cover.
A climber adds load; about 15 kg above the cover weight triggers the alarm.
The processor sends a dry contact (N.O. / N.C.) or RS485 message.
CCTV, siren and floodlight respond on site.
The mobile app, the security control room and D-Command Control receive the event.
Every image opens full size. Product sheets are shown whole, exactly as D-FENCE publishes them.
Paste it into your specification. It defines the system by what it must do, so any alternative must meet every point.
The system shall be D-Tech by D-FENCE Electronic Fencing and Security Systems Ltd. (ISO 9001:2015 certified quality management), or an approved equivalent that meets every requirement in this section.
An ultra-slim pressure sensor hidden under wall copings, gates and floors: it reports the climb and leaves the design untouched.
Before installation, the contractor shall submit the manufacturer's datasheet, the installation instructions and the zone layout for approval.
Tell us the site, the threat and the line. D-FENCE engineers propose the right barrier, sensor and platform, ready for your integrator.

Intruders climbing over your wall?
A patented strain-gauge strip under the coping. Real weight on the wall raises the alarm; birds, cats and wind do not.

Intruders crossing floors, decks or steps unseen?
Pressure sensors under tiles, stone, wood or steel turn any floor, deck or stair into a silent alarm zone.

Alarms lost between separate systems?
Every sensor, camera and alarm on one geolocated map, in the control room or on a phone.
Products, solutions and pages